And assuming your Mac has a USB 3.0 port you can plug straight in.Does Windows 7 recognize the full capacity of external hard drives larger than 2.2TB without any special formatting or partitioning needed?Yes, Windows 7 works fine with large volumes, both internal and external. The My Passport (not for Mac version) has a type A cable end on the end you connect to your Mac. Hi guys, i hope someone here could help me with a problem that im facing I recently bought a passport for mac and it came formatted as mac os extended journal The hard drive’s behaviour is normal on my osx lion, however when i plugged the hard drive in when running windows 7 via boot camp, the OS reported that the device (hard drive) failed to install, and when i checked what seem to cause this Both the WD My Passport and the My Passport for Mac are powered by your Mac’s USB port.In that case you need to have a UEFI motherboard that understands GPT-partitioned disks. Once partitioned, you can format the volume using the standard NTFS file system.The only complication you'll run into is if you want to use a boot volume that's greater than 2TB. You need to use GPT partitions rather than MBR partitions, but the Disk Management tool in Windows 7 will do this seamlessly and automatically.
Wd My Passport On Win 7 Windows 7 Via BootYou don't need to format it. Windows will see a drive larger than 2.2TB (to answer the larger than 2TB question). Finding a new appropriate IRST driver was another exercise in frustration since I already had the last one Dell offered or recommended.That's because Sean posted some info (good info) that's not relevant to your main concerns and is really something you don't need to be worrying about at this time.As explained by Sean and myself - First: YES. After considerable research and frustration I traced it down to the Intel Rapid Storage Technology driver needed to be updated. I'm still confused (bolded bit above).What happens when I plug in the > 2.2GB external drive (USB) for the first time?Does Windows 7 automatically recognize the full available capacity of the drive or only up to what's left under 2.2GB?If I partition the drive Windows 7 will know to automatically use GPT partitions?If I don't partition the drive and leave it as one large drive, is it one big GPT partiton?I feel like I'm making this more complicated than it is.I ran into problems with that a few months ago when I replaced the original Seagate Barracuda 1TB HDD that came in my 2010 Dell XPS 8100 with a new WD Black High Performance 1TB HDD that uses "advanced format". Older USB drivers and chipsets wouldn't support this, but anything you buy today should be fine with it.Sorry. Vector magic 115 product keyIf you want to use the drive as is, again, just plug & playIf you do a simple partition, the drive should automatically choose NTFS, if not just choose that and be done. Windows 7 will use a larger than 2.2 TB hard drive.No need to partition unless you have a reason to do so. Other than that, don't obsess over this. So, even if you had say a 1TB drive, Windows would only use 931GB out of the 1000GB (1TB) the drive is sold as.I posted some info if you're interested in the why and how of things. In keeping things simple, it's the way Windows reads drives. Your current system would need to be at least ten years old (if not older) for it not to support drives larger than 2TB.Sorry, I guess I went into more detail than was appropriate. All modern systems support drives larger than 2TB. Most external drives shipped today are already formatted so there's no need to do one.No need to. If on the other hand you plug in a drive and it asks to chose a file system. Windows may say something like "the drive has to be prepared for use" or some such thing (it's been a while since I've done this) - just click "OK" or "Yes" on all the prompts and before you know it you'll have a nice, huge drive to play with.
0 Comments
Leave a Reply. |
AuthorKim ArchivesCategories |